Moving around the case to the “HDD” subsection we see that this is the same section that can be used to house a 240mm radiator and that the subsection can also mount a rear exhaust fan:

One HDD rack is included with the case and each rack can mount four 3.5″ drives (or 8 SSDs with accessories):

The rack is attached to a plate that will cover the 240mm radiator mount and this plate can support another HDD rack which is another optional extra. It mounts down with four screws very simply and wiring should be neat and tidy. Note that the HDD rack can not be rotated 90 degrees:

If instead you desire to mount a 240mm radiator to the base there is a good amount of space:

A 30mm radiator with push/pull fans has plenty of clearance, though an extra thick radiator like an alphacool monsta may struggle to fit.

Given the photo you may ask why a 360 or 280 mount isn’t included instead. That is because a 360 radiator mount would clash with the front i/o panel, while the chamber does not have the width for a 280 radiator.

The i/o panel mounts in the little hole on the bottom left:

This particular version is the “full monty” as it contains USB headers and headphone/microphone sockets in addition to the power/reset buttons. It is again an optional extra ($25 cost adder).

5 COMMENTS

Comments are closed.